HAUTKLEBER Sauer 5001, 2X28 g

Product features

SAUER-Skin glue is an accessory for the SAUER-latex urinal condoms (original, extra thin).It serves to create a firm and tight connection between the condom and the shaft of the penis.The skin glue is applied to intact skin.

Application instructions

Gluing process of a SAUER-urinal condom

If possible, the condom should be attached under the erection.The skin glue is applied to dry, untreated skin.If pubic hair is present, a drape can be used.The condom is unrolled about 4-6 cm, placed on the tip of the penis and then rolled over the glans.If there is no erection, the skin adhesive is applied as a thin film in a ring 2-3 cm wide with gentle counter pressure, so that a complete adhesive film is created.The condom is then unrolled over the adhesive film and pressed down.The ring remaining behind the adhesive surface can be cut off or torn off completely with rounded scissors if pressure points are feared or the penis retracts sharply.

Removing a SAUER-urinal condom

For hygiene reasons, the condom should be removed after 24 hours at the latest.It is rolled or pulled off from behind towards the tip of the penis.You should not pull too hard to avoid damaging the skin.Any adhesive residue can be rubbed off with a dry cloth or your fingers.

Disposal instructions

Glue tube and contents should be disposed of as hazardous waste.Disposal should be carried out in accordance with official regulations.

Ingredients

The trade name of the product can be found on the label.The main ingredients are natural rubber, lanolin, zinc oxide and a solvent mixture.The solvent mixture consists of naphtha, cyclohexane, n-heptane and ethanol.There is also a version without ethanol.

Notes

No prescription is required for this product.The SAUER-skin glue can be purchased from your mail-order pharmacy.

Manufacturer

Manfred Sauer GmbH, Neurott 7, 74931 Lobbach